12 Spline Stump Jumper Hub for Bush Hog, Hico, and More
Found on many Rotary Cutters using 40HP gearboxes such as: Bush Hog, Modern, Kodiak, Big Bee, Sidewinder, Woods and more
Weld this steel constructed blade hub on the Blade Carrier (Stump Jumper), so that the safe operation continues.
Specifications
- 12 Spline Blade Hub
- Used on 40HP Gearboxes
- Steel Construction
- 2" High with 1/4" lip
- 2-7/8" OD
- 1-1/2" ID
- Splines are tapered slightly
- Customer must weld onto existing blade carrier or stump jumper pan
WARNING Products may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.For more information, visit www.P65Warnings.ca.gov
Install this replacement hub on DH40GB and DH40GBSPLINE gearboxes to continue a smooth operation. This blade hub is constructed from steel with a 12 spline center. The center features a 1/4 in. raised lip so that the hub remains intact while the gearbox is in motion.
Found on many Rotary Cutters using 40HP gearboxes such as: Bush Hog, Modern, Kodiak, Big Bee, Sidewinder, Woods and more
Specifications
- 12 Spline Blade Hub
- Used on 40HP Gearboxes
- Steel Construction
- 2" High with 1/4" lip
- 2-7/8" OD
- 1-1/2" ID
- Splines are tapered slightly
- Customer must weld onto existing blade carrier or stump jumper pan
