3 Point Lower Lift Arm (LH) for Case Model 600, Ford Models 501, 1841 Industrial, 4120 and More
- Category 1
- It accommodates 7/8" drawbar or lower link pins
- Measures 31-5/8" center to center on the ball
- 3" Wide
- Left hand side
- Eyelet Brackets Attached
- If purchasing for a tractor 1954 and later, please measure the length before ordering.
- Offset tractors must drill hole for sway chain.
WARNING Products may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.For more information, visit www.P65Warnings.ca.gov
Ford- Fits: 600, 601, 611, 620, 621, 630, 631, 640, 641, 650, 651, 660, 661, 671, 681, 700, 701, 740, 741, 771, 800, 801, 811, 820, 821, 840, 841, 850, 851, 860, 861, 871, 881, 900, 901, 941, 950, 951, 960, 961, 971, 981, Industrial: 1801, 1811, 1821, 1841, 1871, 1881; 2000 4 cylinder, 2030, 2031, 2100, 2110, [ 2111, 501, 541 (Must Drill Hole For Sway Chain On Offsets) ], 2120, 2121, 2130, 2131, 2300, 4000 4 cylinder, [ 4030 4 cylinder, 4031, 4040, 4100, 4110, 4120, 4121, 4130 4 cylinder, 4131, 4140 (4 cylinder) ]; Replaces:D0NN555C
Ford / New Holland - Fits: (1965 & Up) 2000, 2310, 2600, 2610, 2810, 2910, 3000, 3600, 3610;Industrials: 230A, 231, 233, 333, 334, 335, 340, 340A, 340B, 445, 445A, 530A, 531, 540, 540A, 540B, 545, 545A
- Category 1
- It accommodates 7/8" drawbar or lower link pins
- Measures 31-5/8" center to center on the ball
- 3" Wide
- Left hand side
- Eyelet Brackets Attached
- If purchasing for a tractor 1954 and later, please measure the length before ordering.
- Offset tractors must drill hole for sway chain.
Replaces FDS383
